NDA Company
Sign upDeutsch

How to Make a Yeat Type Beat: Rage Synths, 808s, Bells

Updated 21 Nov 2026

By · an anonymous producer collective with 100M+ streams and credits with Gunna, Coi Leray and Trettmann. Every loop we put out is played by hand, no AI.

NDA Company currently has 86 free Yeat type loops, from 133 to 180 BPM (most around 140 BPM), most often in Dmin and Fmin; typically Virtual, Dark and Synth.

Yeat
Yeat, photo from Spotify

A Yeat type beat lives on a glassy rage synth with glide, two or three 808s stacked underneath, and a bell tuned to the root on every second hi-hat. Dark analog synths over super bouncy drums, nothing more. This guide pulls the moves straight from producer tutorials and hands you free loops to start on. His 2026 double album ADL pushes the rage sound further, so the same bells, 808s and detuned synths still apply.

▶ Have a listenTap to play, no login
  • Monkeyball140 BPM · Bmin
  • Nasty140 BPM · Cmin
  • Maiskolben140 BPM · Bmin
  • Combo140 BPM · Dmin
  • MOVIE140 BPM · Dmin
Hear all 86 loops

The basics

Tempo140 to 150 BPM
TagsVirtual, Dark, Hard
Keyminor
Instrumentsglassy synth with glide
Loops to start with

You do not need a finished beat to start. Play the Yeat loops above and grab any of them free as mp3 at the bottom.

What BPM and key is a Yeat type beat?

A Yeat type beat sits in a minor key, often D sharp minor, C minor or B minor, at 140 to 150 BPM with a glassy gliding synth. Most Yeat type beats run 140 to 150 BPM and 145 is the value tutorials reach for first. One producer sets it to "145 or around that" before anything else. Upwards it goes to 160, but 145 is the safe pocket for that rage bounce.

The key is minor. D sharp minor, C minor, D minor, B minor and C sharp minor all show up in the tutorials. Setting the BPM and key before you touch the melody makes everything after it easier.

Build the chords off the fifth and sixth degrees of the scale. That one progression almost always loops well on a Yeat type beat. Stack the chord from root and fifth and pull the middle note out, so only the root and the fifth ring. Keeps it dark instead of pretty.

How do you make a Yeat type beat?

You make a Yeat type beat from a glassy gliding minor synth loop, two or three 808s at once, a root-tuned bell, triplet hats and sound changes instead of new melodies. The loops in step 1 stream right here and the mp3 is free. Work through the six steps below. Most producers build the full drums first and drop the melody after, but here the loop is already done, so the order flips.

1. Pick a sample. Glassy or gliding synth in minor, 140 to 150 BPM. Take one of the loops right below, ideally one with little going on and a lot of character. These beats are simple and repetitive on purpose, the vibe carries them.

2. Lay the 808. It is the foundation and it is two or three of them at once, not one. Find the pattern with a single 808 like the Spins, then clone the track and only swap the sound in the copy. Every single one on cut-itself and limited in polyphony. Add slides on the 808 for that signature Yeat glide.

3. Hi-hats on top. Start with a simple triplet pattern for the bounce, then copy and paste it through the whole melody. Under it, a second hat sound as a running fast roll with uneven velocity. Then the bell, tuned to the root, on every second hat.

4. Clap and kick. Clap on 2 and 4, either plain or two layered, one low pitched and one higher so it hits hard. A small perc right in front of the 808 adds bounce. Kick last and sparing, muted for whole sections because the stacked 808s already fill the bottom.

5. Try the pitch. Only once the drums sit. Pitch the lead up on the second half of the hook so it cuts harder, drop a part down for contrast. Both moves show up in the tutorials and both sound insane in this style.

6. Arrange. Keep it simple, less is more. The beat lives on sound changes, not new melodies: another 808 in the verse, small glitches at the transitions, hook early. That keeps it catchy and easy to place.

Which sounds do you actually need?

Not one 808, two or three at the same time. One long distorted one as the carrier, one short hard one for the accents, a Detroit-style bass works well there, plus a sub pitched up and mixed underneath. Start with one like the Spins to find the placement, then clone and change the sound. Every single one on cut-itself with polyphony limited, otherwise they fight and the low end turns to mud.

Envelope on each 808: hold all the way up, everything else at zero. The note then stops exactly where you place its end, which is the whole trick. Add slide notes on the 808 for that moving Yeat bass.

The bell is the signature. Tuned to the root, on every second hi-hat. That one move is what makes a trap beat read as a Yeat type beat. One tutorial literally ends every drum section with "add bell and you're done."

Hi-hats start as a simple triplet pattern for the bounce, then copy it across the whole melody. Add a second hat underneath as a continuous fast roll with uneven velocity. Hit the randomise button so pan, velocity and a little pitch move together and nothing sounds straight.

For the melody one glassy or gliding rage synth is enough. Serum and Vital are the two plugins named, Vital is the free one and does the job. Layer a few saw waveforms to build the glassy tone, set the glide to around 400 ms, widen it with a stereo shaper and pull the harsh top end down with an EQ. ShaperBox for pan and crush does more for the dark sound than any preset folder. If you want the darker Don Toliver flavour, an analog synth preset like Static over an effect rack with an old-radio setting nails that worn, dark tone.

For counter melodies, load one-shot keys and set the sampler to stretch so every note plays in tempo. Render it alone, reverse it and automate the pan from one side to the other for a moving texture. Dropping a bass under the chords first makes the counter melodies far easier to find.

How do you arrange a Yeat type beat in bars?

The beat moves through sound changes, not new melodies. Two patterns come up again and again.

First, glitches and stutter. Cut a small piece out at a single spot, duplicate it and drop it back offset. Four to eight bars apart is enough, more than that and it stops being a surprise.

Second, start very plain and add elements later. A full intro, then the hook, then pitch the lead up on the second half of the hook for the verse, then bring a crazy bell or key back in. Another 808 in the verse than in the hook, and passages where the energy drops out again. Keep the first 8 bars simple and open up at the end of 8 or 16 with rolls and a pitch automation.

How do you pitch the sample up and down?

The position of the loop is not fixed. A few semitones change how hard the synth hits.

Up the synth gets sharper and cuts more, down it gets wider and slower. Pitching the lead up on the second part of the hook is a standard Yeat move.

If you pitch, every 808 and the bell have to move with it, otherwise the key falls apart.

What mistakes should you avoid?

The common mistakes are one melodic layer too many, going melodic where it should be dark, not enough time in the synth and skipping the bell. One melodic layer too many. These beats are simple and repetitive by design, one solid idea is enough and everything after builds on it.

Melodic where it should be dark. The first semitones above the root sound friendly, so start at the second pair and keep it minor.

Not enough time in the synth. The sound decides more than the pattern, so stay in Vital or Serum, layer your saws and shape the tone until it sits before you move on.

Skipping the bell. Without a root-tuned bell on every second hat it reads as a generic rage beat, not a Yeat one.

How do you build a Yeat type beat in FL Studio and Logic?

All the tutorials run in FL Studio, but the DAW matters less here than the synth and one sampler setting.

FL Studio: every 808 in its own sampler channel, cut-itself on, hold envelope at the top and everything else at zero. Find the pattern with one 808 first, then clone the channel and only swap the sound in the copy. Randomise velocity, pan and pitch straight from the piano roll. Route all the melody sounds to a single mixer track and put your old-radio and width effects on that bus for the analog glue.

Logic: Quick Sampler in mono for every 808, hold up in the amp envelope, one track each. Step Sequencer for the triplet hats and Humanize for the velocity. Tune the bell to the root in the sampler, not with a pitch plugin, otherwise it drifts when you transpose.

How do you use the loops from NDA Company?

Every loop here is played by hand, no AI, and free as an mp3. Grab a glassy minor loop from the list, run it through the six steps and you have a Yeat type beat in under an hour.

Loops to start with

  • ▶
    Monkeyball
    140 BPM · Bmin
    DarkHardSimple
    @ndacompany
    ↓
  • ▶
    Nasty
    140 BPM · Cmin
    DarkHardVirtual
    @ndacompany
    ↓
  • ▶
    Maiskolben
    140 BPM · Bmin
    DarkHardSimple
    @ndacompany
    ↓
  • ▶
    Combo
    140 BPM · Dmin
    DarkHardSynth
    @ndacompany
    ↓
  • ▶
    MOVIE
    140 BPM · Dmin
    DarkHardSynth
    @ndacompany
    ↓
Start now

Pick a loop and drag it into your DAW. 808 under it, clap on top, your first Yeat beat is running.

All Yeat loops

BPM, key and vibe of the Yeat loops

Tempo, key and mood of the Yeat loops, straight from our catalog.

LoopBPMKeyVibe
Monkeyball140BminDark, Hard, Virtual
Nasty140CminDark, Hard, Virtual
Maiskolben140BminDark, Hard, Virtual
Combo140DminDark, Hard, Virtual
MOVIE140DminDark, Hard, Virtual
Mosquitos140D#minDark, Hard, Hyper, Virtual
Evil no Angel140G#minDark, Hard, Virtual
2BLESSED140CminDark, Virtual
DEVIL143DmajDark, Hard, Virtual
Madness137DminAmbient, Dark, Virtual
Want to flip these loops?

Every loop as WAV + the real MIDI, plus 900+ starters. Hand-played, no AI. 1 month free.

See NDA+

Sources

🎧 Hear all Yeat loops →

Download free Yeat loops →

Free Yeat loops to start with

70+ Free Loops

+ 60 more Yeat loops

See all Yeat loops

Browse all Artists & Genres

Yeat Type Loops

Where to get free loops

Related guides

FAQ

What BPM is a Yeat type beat?

140 to 150 BPM, 145 is the most common starting value, upwards to 160.

What key is a Yeat type beat in?

Minor, often D sharp minor, C minor, D minor or B minor. Root and fifth are enough for a chord, pull the middle note out.

What instruments do I need?

A glassy rage synth with glide for the lead, two or three 808s, triplet hats, a clap and the root-tuned bell.

Which synth do producers use for Yeat beats?

Serum or Vital. Vital is free and does the job: layer saw waveforms, set glide to around 400 ms and shape the top end with an EQ and ShaperBox.

Which DAW do I need?

Any. Every tutorial uses FL Studio, but the synth matters more than the DAW, plus something that cuts the sound up rhythmically.

Can I pitch the loop?

Yes. Pitch the lead up on the second half of the hook for extra bite, drop a part down for contrast. Every 808 and the bell have to move with it.

Can I use your loops for free?

Yes, every loop is a free mp3. Not royalty-free: every release and beat sale runs on a 50/50 publishing split with NDA Company.

They are not royalty-free. Free in your own beats, no upfront payment. A 50/50 publishing split with NDA Company applies to every release, including beat sales and leases. License Terms

About NDA · All Artists & Genres · Free Loop Kits · NDA+ (WAV + MIDI) · Guides · Free Type Beat Loops · Loops by BPM & key · Splice Alternative · Looperman Alternative · Loops for FL Studio